QoS Commands
OmniSwitch CLI Reference Guide November 2009 page 38-3
qos
Enables or disables QoS. This section describes the base command with a single required option (enable
or disable).
In lieu of these options, the base command (qos) may be used with other keywords to set up global QoS
configuration. These keywords are listed here and described as separate commands later in this chapter. In
addition, some keywords have a no form to remove the parameter or return it to its default.
qos {enable | disable}
[trust ports]
[default servicing mode]
[forward log]
[log console]
[log lines lines]
[log level level]
[default bridged disposition {accept | deny | drop}]
[default multicast disposition {accept | deny | drop}]
[stats interval seconds]
[user-port {filter | shutdown} {spoof | bpdu | rip |}
Syntax Definitions
enable Enables QoS. The QoS software in the switch classifies flows coming
into the switch to attempt to match them to QoS policies. If a match is
found, the policy parameters are applied to the flow. The enable setting
may be used alone or in conjunction with optional command keywords.
disable Disables QoS. Flows coming into the switch are not matched to poli-
cies. The disable setting cannot be used with any other command
keyword.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• When QoS is disabled, flows coming into the switch are classified but not matched to a policy. Traffic
is treated as best effort and assigned to default queues.
• The command keywords may be used with or without enable; these keywords cannot be used with
disable.
parameter default
enable | disable enable
To Next Page
Loading...
