QoS Commands
page 38-26 OmniSwitch CLI Reference Guide November 2009
debug qos internal
Displays debugging information for QoS internal to the switch.
debug qos internal [slice slot/slice] [flow] [queue] [port] [l2tree] [l3tree] [vector] [pending] [verbose]
[mapper] [pool] [log] [pingonly | nopingonly]
Syntax Definitions
slot/slice The slot number and slice for which you want to view debugging infor-
mation. A slice is a logical section of hardware that corresponds to
particular ports on a network interface module.
flow Displays information about QoS flows.
queue Displays information about QoS queues.
port Displays information about QoS ports.
l2tree Displays information about Layer 2 flows.
l3tree Displays information about Layer 3 flows.
vector Displays information about vectors.
pending Displays information about pending QoS objects.
verbose Sets the output to verbose mode for more detailed information.
mapper Displays information about QoS mapping flows to queues.
pool Displays information about the buffer pool.
log Displays information about QoS information that is logged.
pingonly On an OmniSwitch 6624/6648, specifies that any policies configured
with an ICMP protocol condition apply only to ICMP echo-requests.
nopingonly Configures the switch so that any policies configured with an ICMP
protocol condition apply to any ICMP packets.
Defaults
Debugging is disabled by default.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Use the debug qos command to set the level of log detail in the QoS log.
parameter default
pingonly | nopingonly nopingonly
To Next Page
Loading...
