QoS Commands
OmniSwitch CLI Reference Guide November 2009 page 38-29
qos apply
Applies configured global QoS and policy settings to the current configuration (changes will be active and
stored in flash).
qos apply
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• This command is required to activate all QoS and policy commands. This is the only command that
causes current changes to be written to flash.
• Rules are configured through the policy rule command, but are not active on the switch until you enter
qos apply.
Examples
-> qos apply
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaQoSConfigTable
alaQoSConfigApply
qos revert Removes any policies configured through policy rule but not applied to
the current configuration through the qos apply command.
qos reset Resets the QoS configuration to its default values.
qos flush Deletes all pending policy information.
To Next Page
Loading...
