QoS Commands
OmniSwitch CLI Reference Guide November 2009 page 38-57
Release History
Release 6.6.1; command was introduced.
Related Commands
Max Depth The maximum queue depth, in bytes. Configured through the policy
action maximum depth command.
Packets Xmit/Drop The number of packets transmitted/dropped from this queue.
Type The type of queuing performed on this queue (pri, wrr, drr).
Action The action that created the queue. A second line displays parameters
specified by the action. The actions are as follows:
• Default —Set up for traffic that does not match a condition on the
port.
• Flood—Set up for flooded or broadcast traffic.
• Best Effort—Set up for traffic that does not match a condition on
the VPN.
• QOS—Created by the switch because the traffic matched a condi-
tion. When traffic matches a condition and queue is set up, another
line displays to show the parameters specified by the action corre-
sponding to the condition. An asterisk displays in fields where the
parameter was not specified by the action. In other words, the first
line shows what is actually happening in the queue; the second line
shows what the action specified.
policy rule Configures a policy rule on the switch. A rule is made up of a condition
(for classifying incoming traffic) and an action (to be applied to outgo-
ing traffic).
output definitions (continued)
To Next Page
Loading...
