Alcatel-Lucent OmniSwitch 6250 - Reloading All Switches in a Stack; Software Synchronization During a Full Reload; Effects of Saved Slot Number Information on the Reload Process

Network Time Protocol Commands
page 5-12 OmniSwitch 6250 CLI Reference Guide November 2009
show ntp client
Displays information about the current client NTP configuration.
show ntp client
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
This command displays the current configuration parameters for the NTP client. The display is slightly
different depending on what has been configured on the client. See the Examples section for more infor-
mation.
Examples
-> show ntp client
Current time: SAT APR 16 2005 00:19:02 (UTC)
Last NTP update: SAT APR 16 2005 00:06:45 (UTC)
Client mode: enabled
Broadcast client mode: disabled
Broadcast delay (microseconds): 4000
Release History
Release 6.6.1; command was introduced.
output definitions
Current time The current time for the NTP client.
Last NTP update The time of the last synchronization with an NTP server.
Client mode Whether the NTP client software is enabled or disabled.
Broadcast client mode What NTP mode the client is running in, either client or broadcast.
Broadcast delay The number of microseconds in the advertised broadcast delay time.
This field is absent if the client broadcast mode is disabled.