QoS Policy Commands
OmniSwitch CLI Reference Guide November 2009 page 39-35
[destination port slot/port[-port]]
[destination port group group_name]
no policy condition condition_name
Syntax Definitions
condition_name The name of the condition. Any alphanumeric string.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• A policy condition and a policy action are combined to make a policy rule. See the policy rule
command page for more information.
• Use the qos apply command to activate configuration changes.
• If multiple keywords are defined for a single condition, the traffic flow must match all of the parame-
ters in the condition before the rule is enforced.
• Use the no form of the command to remove a condition from a policy rule.
• At least one parameter must be associated with a condition.
• If the snapshot command is entered after the policy condition command is configured, the resulting
ASCII file will include the following additional syntax for the policy condition command:
from {cli | ldap | blt}
This syntax indicates how the condition was created. The cli and ldap options may be changed by a
user modifying the ASCII file; however, changing this setting is not recommended. The blt option
indicates a built-in condition, this option is not configurable.
Examples
-> policy condition cond4 source port 3/1
Release History
Release 6.6.1; command was introduced.
To Next Page
Loading...
