Network Time Protocol Commands
page 5-16 OmniSwitch 6250 CLI Reference Guide November 2009
show ntp server status
Displays the basic server information for a specific NTP server or a list of NTP servers.
show ntp server status [ip_address | domain_name]
Syntax Definitions
ip_address The IP address of the NTP server to be displayed.
domain_name The domain name of the server to be displayed. This is usually a text
string.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• This command displays a selected server or a list of servers with which the NTP client synchronizes.
• To display a specific server, enter the command with the server’s IP address or domain name. To
display all servers, enter the command with no server IP address.
Examples
-> show ntp server status
-> show ntp server status 198.206.181.139
IP address = 198.206.181.139,
Host mode = client,
Peer mode = server,
Prefer = no,
Version = 4,
Key = 0,
Stratum = 2,
Minpoll = 6 (64 seconds),
Maxpoll = 10 (1024 seconds),
Delay = 0.016 seconds,
Offset = -180.232 seconds,
Dispersion = 7.945 seconds
Root distance = 0.026,
Precision = -14,
Reference IP = 209.81.9.7,
Status = configured : reachable : rejected,
Uptime count = 1742 seconds,
Reachability = 1,
Unreachable count = 0,
Stats reset count = 1680 seconds,
Packets sent = 1,
Packets received = 1,
Duplicate packets = 0,
To Next Page
Loading...
