QoS Policy Commands
OmniSwitch CLI Reference Guide November 2009 page 39-101
policy condition source port
Configures a source port number for a policy condition. Use the no form of the command to remove a
source port number from a condition.
policy condition condition_name source port slot/port[-port]
policy condition condition_name no source port
Syntax Definitions
condition_name The name of the condition. May be an existing condition name or a new
condition.
slot/port The slot and port number (or range of ports) on which the frame is
received.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Use the no form of the command to remove a source port from a condition; however, at least one classifi-
cation parameter must be associated with a condition.
Examples
-> policy condition cond2 source port 3/1
-> policy condition cond3 source port 3/2-4
Release History
Release 6.6.1; command was introduced.
Related Commands
qos apply Applies configured QoS and policy settings to the current configuration.
policy condition Creates a policy condition.
show policy condition Shows information about policy conditions configured on the switch.
To Next Page
Loading...
