QoS Policy Commands
page 39-118 OmniSwitch CLI Reference Guide November 2009
policy action maximum bandwidth
Configures a maximum bandwidth value for a policy action.
policy action action_name maximum bandwidth bps
policy action action_name no maximum bandwidth
Syntax Definitions
action_name The name of the action.
bps The desired value for maximum bandwidth, in bits per second. The
value may be entered as an integer (for example, 10000) or with abbre-
viated units (for example, 10k). If the value is entered in bits per second,
the switch rounds the value up to the nearest thousand.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of the command to remove a maximum bandwidth value from an action.
• Note that the bandwidth may be entered in bits per second. Alternatively, the bandwidth may be
entered in abbreviated units (1k, 2k, etc). If the bandwidth value is entered in bytes, the switch rounds
the value to the nearest thousand bytes. For example, if you enter 1 to 1024, the result is 1K. If you
enter 1025 to 2048, the result is 2K.
Examples
-> policy action action4 maximum bandwidth 10000
-> policy action action4 maximum bandwidth 10k
-> policy action action4 no maximum bandwidth
Release History
Release 6.6.1; command was introduced.
To Next Page
Loading...
