QoS Policy Commands
page 39-126 OmniSwitch CLI Reference Guide November 2009
policy action dscp
Configures a Differentiated Services Code Point (DSCP) value to be set in an outgoing flow for traffic that
matches rules with this action.
policy action action_name dscp dscp_value
policy action action_name no dscp
Syntax Definitions
action_name The name of the action.
dscp_value The DSCP value to be set, in the range 0–63.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to remove a DSCP value from a policy action.
• Note that specifying both ToS and DSCP in the same action is not allowed.
• An 802.1p or ToS/DSCP action always sets the packet priority. For 802.1p marking, the priority is set
according to the marked 802.1p. For ToS marking, the priority is set according to the marked ToS. For
DSCP marking, the priority is set according to the marked DSCP.
Examples
-> policy action action2 dscp 61
-> policy action action2 no dscp
Release History
Release 6.6.1; command was introduced.
Related Commands
qos apply Applies configured QoS and policy settings to the current configuration.
policy action Creates a policy action.
show policy action Displays information about actions configured on the switch.
To Next Page
Loading...
