QoS Policy Commands
page 39-158 OmniSwitch CLI Reference Guide November 2009
show policy classify source interface type
Specifies a source interface type for a hypothetical packet to show how the QoS software in the switch will
handle the packet.
show policy classify {l2 | l3 | multicast} [applied] source interface type {ethernet | wan | ethernet-10 |
ethernet-100 | ethernet-1G | ethernet-10G}
Syntax Definitions
l2 Uses the Layer 2 classifier for the hypothetical packet.
l3 Uses the Layer 3 classifier for the hypothetical packet.
multicast Uses the multicast IGMP classifier for the hypothetical packet.
applied Indicates that only applied policies should be examined.
ethernet Indicates that the flow’s source port is an Ethernet interface.
wan Indicates that the flow’s source port is a WAN interface. Not supported
currently.
ethernet-10 Indicates that the flow’s source port is 10 Mb Ethernet.
ethernet-100 Indicates that the flow’s source port is 100 Mb Ethernet.
ethernet-1G Indicates that the flow’s source port is 1 gigabit Ethernet.
ethernet-10G Indicates that the flow’s source port is 10 gigabit Ethernet.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use this command to determine if the switch will classify the traffic condition specified and match it to
a policy. By default the classifier only tests pending policies (policies that have not yet been applied).
Use the applied keyword to test only those policies that have been applied.
• Use the qos apply command to activate saved policies.
Examples
-> policy classify l2 source interface type ethernet
See the output example given on page 39-143 for more information about the potential screen display.
Release History
Release 6.6.1; command was introduced.
To Next Page
Loading...
