QoS Policy Commands
page 39-164 OmniSwitch CLI Reference Guide November 2009
show policy classify source ip
Specifies a source IP address for a hypothetical packet to show how the QoS software in the switch will
handle the packet.
show policy classify {l2 | l3 | multicast} [applied] source ip ip_address
Syntax Definitions
l2 Uses the Layer 2 classifier for the hypothetical packet.
l3 Uses the Layer 3 classifier for the hypothetical packet.
multicast Uses the multicast IGMP classifier for the hypothetical packet.
applied Indicates that only applied policies should be examined.
ip_address The source IP address.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use this command to determine if the switch will classify the traffic condition specified and match it to
a policy. By default the classifier only tests pending policies (policies that have not yet been applied).
Use the applied keyword to test only those policies that have been applied.
• Use the qos apply command to activate policies.
Examples
-> show policy classify l3 source ip 1.2.3.4
See the output example given on page 39-143 for more information about the potential screen display.
Release History
Release 6.6.1; command was introduced.
To Next Page
Loading...
