QoS Policy Commands
page 39-190 OmniSwitch CLI Reference Guide November 2009
show policy map group
Displays information about pending and applied policy map groups.
show [applied] policy map group [group_name]
Syntax Definitions
applied Indicates that only map groups that have been applied should be
displayed.
group_name The name of the policy map group for which you want to display infor-
mation; or a wildcard sequence of characters for displaying information
about map groups with similar names. Use an asterisk (*) to indicate a
wildcard character.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Information for all policy map groups displays unless group_name is specified.
• The display may include any of the following characters:
Examples
-> show policy map group
Group Name From Entries
+tosGroup cli 1-2:4
4:5
character definition
+ Indicates a new policy port group.
- Indicates the policy port group is pending deletion.
# Indicates that the policy port group differs between
the pending/applied port groups.
output definitions
Group Name The name of the map group, configured through the policy map group
command.
From The origin of the port group: cli indicates that the entry was configured
on the switch; ldap indicates the entry was configured through Policy-
View.
Entries The slot/port combinations associated with the port group.
To Next Page
Loading...
