QoS Policy Commands
page 39-192 OmniSwitch CLI Reference Guide November 2009
show policy action
Displays information about pending and applied policy actions configured on the switch.
show [applied] policy action [action_name]
Syntax Definitions
applied Indicates that only actions that have been applied should be displayed.
action_name The name of the action for which you want to display information; or a
wildcard sequence of characters for displaying information about
actions with similar names. Use an asterisk (*) to indicate a wildcard
character.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Information for all policy actions displays unless action_name is specified.
• The display may include any of the following characters:
Examples
-> show policy action
Bandwidth Max
Action Name From Disp Pri Share Min Max Depth Bufs
action1 cli accept No
+action2 cli accept No
test_action cli accept Yes
-> show policy action action2
Bandwidth Max
Action Name From Disp Pri Share Min Max Depth Bufs
action2 cli accept No
character definition
+ Indicates a new policy action.
- Indicates the policy action is pending deletion.
# Indicates that the policy action differs between the
pending/applied actions.
To Next Page
Loading...
