QoS Policy Commands
page 39-196 OmniSwitch CLI Reference Guide November 2009
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaQoSConditionTable
alaQoSConditionName
alaQoSConditionSource
alaQoSConditionSourceSlot
alaQoSConditionSourcePort
alaQoSConditionSourcePortGroup
alaQoSConditionDestinationSlot
alaQoSConditionDestinationPort
alaQoSConditionDestinationPortGroup
alaQoSConditionSourceInterfaceType
alaQoSConditionDestinationInterfaceType
alaQoSConditionSourceMacAddr
alaQoSConditionSourceMacMask
alaQoSConditionSourceMacGroup
alaQoSConditionDestinationMacAddr
alaQoSConditionDestinationMacMask
alaQoSConditionDestinationMacGroup
alaQoSConditionSourceVlan
alaQoSConditionDestinationVlan
alaQoSCondition8021p
alaQoSConditionSourceIpAddr
alaQoSConditionSourceIpMask
alaQoSConditionSourceNetworkGroup
alaQoSConditionDestinationIpAddr
alaQoSConditionDestinationIpMask
alaQoSConditionDestinationNetworkGroup
alaQoSConditionMulticastIpAddr
alaQoSConditionMulticastIpMask
alaQoSConditionMulticastNetworkGroup
alaQoSConditionTos
alaQoSConditionDscp
alaQoSConditionTcpFlags
output definitions
Condition Name The name of the condition, configured through the policy condition
command.
From The origin of the condition: cli indicates that the entry was configured
on the switch; ldap indicates the entry was configured through Policy-
View.
Scr The source address associated with the condition.
Dest The destination address associated with the condition.
policy condition Creates a policy condition. The condition determines what parameters
the switch uses to classify incoming flows.
To Next Page
Loading...
