OmniSwitch 6250 CLI Reference Guide November 2009 page 40-1
40 Policy Server
Commands
This chapter describes CLI commands used for managing policies downloaded to the switch from an
attached LDAP server. Policy rules may be created on an attached server through the PolicyView GUI
application. Policy rules may also be created on the switch directly through CLI or SNMP commands.
This chapter describes commands related to managing LDAP policies only. See Chapter 38, “QoS
Commands,” for information about commands for creating and managing policies directly on the switch.
The policy commands are based on RFC 2251 and RFC 3060.
MIB information for policy server commands is as follows:
Filename: alcatelIND1policy.mib
Module: ALCATEL-IND1-POLICY-MIB
The policy server commands are summarized here:
policy server load
policy server flush
policy server
show policy server
show policy server long
show policy server statistics
show policy server rules
show policy server events
To Next Page
Loading...
