Policy Server Commands
page 40-6 OmniSwitch 6250 CLI Reference Guide November 2009
show policy server
Displays information about servers from which policies may be downloaded to the switch.
show policy server
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
This command displays basic information about policy servers. Use the show policy server long
command to display more details about the servers.
Examples
-> show policy server
Server IP Address port enabled status primary
------+--------------+-----+---------+--------+--------
1 208.19.33.112 389 Yes Up X
2 208.19.33.66 400 No Down -
Release History
Release 6.6.1; command was introduced.
output definitions
Server The index number corresponding to the LDAP server.
IP Address The IP address of the LDAP server.
port The TCP/IP port number used by the switch to connect to the policy
server.
enabled Whether or not the policy server is enabled.
status The state of the policy server, Unkn, Up or Down.
primary Indicates whether the server is the primary server; this server will be
used for the next download of policies; only one server is a primary
server.
To Next Page
Loading...
