Policy Server Commands
page 40-10 OmniSwitch 6250 CLI Reference Guide November 2009
show policy server statistics
Displays statistics about policy directory servers.
show policy server statistics
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
This command displays statistics about server downloads. For information about server parameters, use
the show policy server command.
Examples
-> show policy server statistics
Server IP Address port accesses delta successes delta errors delta
------+--------------+-------+---------+-------+----------+-----+-------+------
1 155.132.44.98 16652 793 793 295 295 0 0
2 155.132.48.27 21890 0 0 0 0 0 0
output definitions
Server The index number corresponding to the server.
IP Address The IP address of the LDAP server.
port The TCP/IP port number used by the switch to connect to the policy
server.
accesses The number of times the server was polled by the switch to download
policies.
delta The change in the number of accesses since the last time the policy
server was accessed.
successes The number of times the server was polled by the switch to download
policies and the policies were successfully downloaded.
delta The change in the number of successful policy downloads since the last
time the policy server was accessed.
errors The number of errors returned by the server.
delta The change in the number of errors returned by the server since the last
time the policy server was accessed.
To Next Page
Loading...
