Alcatel-Lucent OmniSwitch 6250 - Ip Multicast Version

IP Multicast Switching Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 41-7
ip multicast version
Sets the default version of the IGMP protocol on the specified VLAN or on the system if no VLAN is
specified.
ip multicast [vlan vid] version [version]
Syntax Definitions
vid VLAN on which to apply the configuration.
version Default IGMP protocol version to run. Valid range is 1 to 3.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• IP Multicast Switching and Routing must be enabled to set the default IGMP protocol version on the
system and/or the specified VLANs.
• If the default IGMP protocol version is already configured on the system, then the VLAN configura-
tion will override the system's configuration.
• Due to protocol inter-operation requirements, this command specifies only a default version of the
IGMP protocol to run.
• To restore the IGMP multicast version to the default (i.e., 2) version on the system if no VLAN is spec-
ified, use ip multicast version followed by the value 0 (e.g., ip multicast version 0) or use
only ip multicast version (e.g., ip multicast version).
• To restore the IGMP multicast version to the default (i.e., 2) version on the specified VLAN, use
ip multicast vlan vid version, followed by the value 0 (e.g., ip multicast vlan 2 version 0) or use
only ip multicast vlan vid version (e.g., ip multicast vlan 2 version).
Examples
-> ip multicast version 3
-> ip multicast version 0
-> ip multicast version
-> ip multicast vlan 2 version 3
-> ip multicast vlan 2 version 0
-> ip multicast vlan 2 version
Release History
Release 6.6.1; command was introduced.
parameter default
version 2