Alcatel-Lucent OmniSwitch 6250 - Ipv6 Multicast Source-Timeout

IP Multicast Switching Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 41-59
ipv6 multicast source-timeout
Configures the expiry time of IPv6 multicast sources on the specified VLAN or on the system if no VLAN
is specified.
ipv6 multicast [vlan vid] source-timeout [seconds]
Syntax Definitions
vid VLAN on which to apply the configuration.
seconds MLD source timeout in seconds. Valid range is 1 to 65535.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• IPv6 Multicast Switching and Routing must be enabled to set the MLD source timeout on the system
and/or the specified VLANs.
• If the MLD source timeout is already configured on the system, then the VLAN configuration will
override the system's configuration.
• To restore the MLD router timeout to its default (i.e., 30 seconds) value on the system if no VLAN is
specified, use ipv6 multicast source-timeout followed by the value 0 (e.g., ipv6 multicast source-
timeout 0) or use only ipv6 multicast source-timeout (e.g., ipv6 multicast source-timeout).
• To restore the MLD router timeout to its default (i.e., 30 seconds) value on the specified VLAN, use
ipv6 multicast vlan vid source-timeout followed by the value 0 (e.g., ipv6 multicast vlan 2 source-
timeout 0) or use only ipv6 multicast vlan vid source-timeout (e.g., ipv6 multicast vlan 2 source-
timeout).
Examples
-> ipv6 multicast source-timeout 100
-> ipv6 multicast source-timeout 0
-> ipv6 multicast source-timeout
-> ipv6 multicast vlan 2 source-timeout 100
-> ipv6 multicast vlan 2 source-timeout 0
-> ipv6 multicast vlan 2 source-timeout
Release History
Release 6.6.1; command was introduced.
parameter default
seconds 30