IP Multicast Switching Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 41-67
ipv6 multicast zapping
Enables or disables MLD zapping on the specified VLAN or on the system if no VLAN is specified.
ipv6 multicast [vlan vid] zapping [{enable | disable}]
Syntax Definitions
vid VLAN on which to apply the configuration.
enable Enable MLD zapping.
disable Disable MLD zapping.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• If the MLD zapping is already enabled on the system, then the VLAN configuration will override the
system's configuration.
• MLD zapping refers to processing membership and source filter removals immediately and not wait-
ing for the protocol's specified time period. This mode facilitates IP TV applications looking for quick
changes between IP multicast groups.
• You can also restore the MLD zapping to its default (i.e., disabled) setting on the system if no VLAN
is specified, by using only ipv6 multicast zapping (e.g., ipv6 multicast zapping).
• You can also restore the MLD zapping to its default (i.e., disabled) setting on the specified VLAN, by
using only ipv6 multicast vlan vid zapping (e.g., ipv6 multicast vlan 2 zapping).
Examples
-> ipv6 multicast zapping enable
-> ipv6 multicast zapping disable
-> ipv6 multicast zapping
-> ipv6 multicast vlan 2 zapping enable
-> ipv6 multicast vlan 2 zapping disable
-> ipv6 multicast vlan 2 zapping
Release History
Release 6.6.1; command was introduced.
parameter default
enable | disable disable
To Next Page
Loading...
