IP Multicast Switching Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 41-87
-> show ipv6 multicast vlan 1
Status: = Enabled
Querying: = Disabled
Proxying: = Disabled
Spoofing: = Disabled
Zapping: = Disabled
Querier Forwarding: = Disabled
Version: = 1
Robustness: = 2
Query Interval (seconds): = 125
Query Response Interval (milliseconds): = 10000
Last Member Query Interval (milliseconds): = 1000
Unsolicited Report Interval (seconds) = 1,
Router Timeout (seconds): = 90
Source Timeout (seconds): = 30:
output definitions
Status Whether the IPv6 Multicast Switching and Routing is Enabled or Dis-
abled (the default status).You can enable or disable IPv6 Multicast
Switching and Routing with the ipv6 multicast status command,
which is described on page 41-37
Querying The current state of MLD querying, which can be Enabled or Disabled
(the default status). You can enable or disable MLD querying with the
ipv6 multicast querying command, which is described on page 41-61
Proxying The current state of MLD proxying on the system, which can be
Enabled or Disabled (the default status). You can enable or disable
MLD spoofing with the ipv6 multicast proxying command, which is
described on page 41-69
Spoofing The current state of MLD spoofing on the system, which can be
Enabled or Disabled (the default status). You can enable or disable
MLD spoofing with the ipv6 multicast spoofing command, which is
described on page 41-31
Zapping The current state of MLD zapping on the system, which can be
Enabled or Disabled (the default status). You can enable or disable
MLD zapping with the ipv6 multicast zapping command, which is
described on page 41-67
Querier Forwarding The current state of MLD querier forwarding on the system, which can
be Enabled or Disabled (the default status). You can enable or disable
MLD Querier forwarding with the ipv6 multicast querier-forwarding
command, which is described on page 41-39.
Version Displays the default MLD version, which can be 1, 2 or 3. Use the ipv6
multicast version command to modify this parameter.
Robustness Displays the MLD robustness value, ranging from 1 to 7. Use the ipv6
multicast robustness command to modify this parameter.
Query Interval (seconds) Displays the time (in seconds) between MLD queries. (The default
value is 125 seconds). You can modify this parameter with the
ipv6 multicast query-interval command, which is described on
page
41-49.
To Next Page
Loading...
