AAA Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 43-49
end-user profile
Configures or modifies an end user profile, which specifies access to command areas. The profile may be
attached to a customer login user account.
end-user profile name [read-only [area | all]] [read-write [area | all]] [disable [area | all]]
no end-user profile name
Syntax Definitions
name The name of the end-user profile, up to 32 alphanumeric characters.
area Command areas on the switch to which the user is allowed or denied
access. Areas include physical, vlan-table, basic-ip-routing, ip-
routes-table, mac-filtering-table, spantree.
Defaults
Areas are disabled for end-user profiles by default.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of the command to delete an end-user profile.
• An end-user profile may not be attached to a user that is already configured with functional privileges.
• If a profile is deleted, but the profile name is still associated with a user, the user will not be able to log
into the switch.
• Use the end-user profile port-list and end-user profile vlan-range commands to configure ports and
VLANs to which this profile will have access. By default, new profiles do not allow access to any ports
or VLANs.
Examples
-> end-user profile bsmith read-only basic-ip-routing ip-routes-table
-> no end-user profile bsmith
Release History
Release 6.6.1; command was introduced.
To Next Page
Loading...
