AAA Commands
page 43-68 OmniSwitch 6250 CLI Reference Guide November 2009
User name = public,
Password expiration = 10/27/2007 11:01 (30 days from now),
Password allow to be modified date = 9/30/2007 10:59 (3 days from now),
Account lockout = None,
Password bad attempts = 0,
Read Only for domains = None,
Read/Write for domains = All ,
Snmp allowed = NO,
User name = default (*),
Password expiration = 10/27/2007 11:01 (30 days from now),
Password allow to be modified date = 9/30/2007 10:59 (3 days from now),
Account lockout = None,
Password bad attempts = 0,
Read Only for domains = None,
Read/Write for domains = System Physical Layer2 Services policy Security ,
Read/Write for families = file telnet dshell debug ip rip ip-routing ipmr ipms ,
Snmp allowed = NO,
(*)Note:
The default user is not an active user account.
It contains the default user account settings,
for new user accounts.
-> show user j_smith
User name = j_smith,
Password expiration = 10/27/2007 11:01 (30 days from now),
Password allow to be modified date = 9/30/2007 10:59 (3 days from now),
Account lockout = Yes (Automatically unlocked after 19 minute(s)from now),
Password bad attempts = 3,
END user profile = u_profile1,
Snmp allowed = YES,
Snmp authentication = SHA,
Snmp encryption = DES
output definitions
User name The user name for this account.
Password expiration The date and time on which the password will expire. This field only
displays if the password expiration is configured specifically for a user,
or a default password expiration is configured globally on the switch
through the user password-expiration command. (Note that the date/
time are based on the switch’s default system date/time or the system
date/time configured through the system date and system time com-
mands.)
Password allow to be modified
date
The earliest date and time on which the user may change the password.
Configured through the user password-min-age command.
Account lockout Indicates if the user account is locked out (Yes or No) and how many
minutes remain until the user account is automatically unlocked. If no
remaining time is displayed, the admin user or a user with admin privi-
leges must manually unlock the account. Configured through the user
lockout-duration and user lockout unlock commands.
Password bad attempts The number of failed password login attempts for this user account.
Read Only for domains The command domains available with the user’s read-only access. See
the table on the next page for a listing of valid domains. This field does
not display if an end-user profile is associated with the user account.
To Next Page
Loading...
