AAA Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 43-69
Possible values for command domains and families are listed here:
Release History
Release 6.6.1; command was introduced.
Read/Write for domains The command domains available with the user’s read-write access. See
the table on the next page for a listing of valid domains. This field does
not display if an end-user profile is associated with the user account.
Read Only for families The command families available with the user’s read-only access. See
the table on the next page for a listing of valid families. This field does
not display if an end-user profile is associated with the user account.
Read/Write for families The command families available with the user’s read-write access. See
the table on the next page for a listing of valid families. This field does
not display if an end-user profile is associated with the user account.
END user profile The name of an end-user profile associated with the user account. Con-
figured through the end-user profile command. This field only dis-
plays if an end-user profile is associated with the user account.
Snmp allowed Indicates whether or not the user is authorized to use SNMP (YES or
NO). SNMP is allowed for the user account when SNMP authentica-
tion is specified for the account.
Snmp authentication The level of SNMP authentication, if any, configured for the user. This
field only displays if the user is authorized to use SNMP.
Snmp encryption The level of SNMP encryption, if any, configured for the user. This
field only displays if the user is authorized to use SNMP.
Domain Corresponding Families
domain-admin file telnet dshell debug
domain-system system aip snmp rmon webmgt config
domain-physical chassis module interface pmm health
domain-network ip rip ip-routing ipmr ipms
domain-layer2 vlan bridge stp 802.1q linkagg ip-helper
domain-service dns
domain-security session aaa
output definitions (continued)
To Next Page
Loading...
