AAA Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 43-79
debug end-user profile
Use this command to display detailed information about profiles or a particular profile.
debug end-user profile name
Syntax Definitions
name The name of the end-user profile, configured through the end-user
profile command.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the show end-user profile command to display basic information about end-user profiles.
• If a particular profile is specified, information will be displayed for the profile and for all indexes
following that profile. (The index value is the way the switch internally tracks profiles and reflects the
order in which profiles are created.)
Examples
-> debug end-user profile
End user profile : jentest, length : 7 for index : 1
End user profile @0x5e781e8
Read area rights : 3f
Read and Write area rights : 0
Physical area rights : 2
vlan table area rights : 2
Basic Ip routing area rights : 2
Ip routes table area rights : 2
Mac filtering table area rights : 2
Spantree area rights : 2
Slot 1, ports : 0 0 0 0
Slot 2, ports : 0 0 0 0
Slot 3, ports : 0 0 0 0
Slot 4, ports : 0 0 0 0
Slot 5, ports : 0 0 0 0
Slot 6, ports : 0 0 0 0
Slot 7, ports : 0 0 0 0
Slot 8, ports : 0 0 0 0
Slot 9, ports : 0 0 0 0
Slot 10, ports : 0 0 0 0
Slot 11, ports : 0 0 0 0
Slot 12, ports : 0 0 0 0
Slot 13, ports : 0 0 0 0
Slot 14, ports : 0 0 0 0
Slot 15, ports : 0 0 0 0
To Next Page
Loading...
