Alcatel-Lucent OmniSwitch 6250 - Show Session Config

Session Management Commands
page 6-32 OmniSwitch 6250 CLI Reference Guide November 2009
show session config
Displays session manager configuration information (e.g., default prompt, banner file name, inactivity
timer, login timer, and login attempts).
show session config
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Use the configuration commands detailed in this section to modify any of the values displayed.
Examples
-> show session config
Cli Default Prompt = ->
Cli Banner File Name = ,
Cli Inactivity Timer in minutes = 60
Ftp Banner File Name = ,
Ftp Inactivity Timer in minutes = 60
Http Inactivity Timer in minutes = 60
Login Timer in seconds = 60
Maximum number of Login Attempts = 2
output definitions
Cli Default Prompt Default prompt displayed for CLI sessions.
Cli Banner File Name Name of the file that contains the banner information that will appear
during a CLI session.
Cli Inactivity Timer in
minutes
Inactivity timer value (in minutes) for CLI sessions. The user is logged
off when this value is exceeded.
Ftp Banner File Name Name of the file that contains the banner information that will appear
during an FTP session.
Ftp Inactivity Timer in
minutes
Inactivity timer value (in minutes) for FTP sessions. The user is logged
off when this value is exceeded.
Http Inactivity Timer in
minutes
Inactivity timer value (in minutes) for HTTP (including WebView)
sessions. The user is logged off when this value is exceeded.