802.1X Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 44-5
802.1x initialize
Re-initializes a particular 802.1X port. Stops traffic on the port; then requires re-authentication of the port.
802.1x initialize slot/port
Syntax Definitions
slot/port The slot and port number of the 802.1x port.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• This command is typically only used for troubleshooting, to reset the port access control mechanism in
the switch.
• When this command is entered, all traffic on the port is stopped; the port is then re-authenticated.
Connectivity is restored with successful re-authentication.
Examples
-> 802.1x initialize 3/1
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
dot1xPaePortTable
dot1xPaePortInitialize
802.1x Configures 802.1X parameters on a particular slot/port.
To Next Page
Loading...
