802.1X Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 44-13
• If the captive-portal parameter is specified with this command, then the Captive Portal authentication
policy is applied to supplicant traffic. See the 802.1x captive-portal policy authentication command
page for more information.
• Configuring non-supplicant classification policies is only supported on 802.1x enabled mobile ports.
• Each 802.1x port can have one supplicant policy and one non-supplicant policy for handling 802.1x
and non-802.1x devices, respectively. Configuring a new supplicant or non-supplicant policy over-
writes any policies that may already exist for the port.
Examples
-> 802.1x 3/1 non-supplicant policy authentication
-> 802.1x 4/1 non-supplicant policy authentication pass group-mobility fail
default-vlan
-> 802.1x 5/1 non-supplicant policy authentication group-mobility captive-portal
-> 802.1x 5/10 non-supplicant policy authentication vlan 27 fail vlan 500 default-
vlan
-> 802.1x 2/1 non-supplicant policy authentication vlan 10 default-vlan
-> 802.1x 6/1 non-supplicant policy authentication pass group-mobility default-vlan
fail captive-portal
Release History
Release 6.6.1; command was introduced.Release 6.3.1; capitive-portal parameter added.
Related Commands
MIB Objects
alaDot1xAuthPolicyTable
alaDot1xNonSuppPolicy
802.1x supplicant policy
authentication
Configures 802.1x authentication device classification policies for sup-
plicants.
802.1x non-supplicant policy Configures device classification policies that do not perform 802.1x or
MAC authentication for non-supplicants.
802.1x policy default Resets the device classification policy to the default policy value for the
802.1x port.
show 802.1x device
classification policies
Displays device classification policies configured for an 802.1x port.
show 802.1x non-supplicant Displays a list of all non-supplicants learned on all 802.1x ports.
To Next Page
Loading...
