Session Management Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 6-35
more size
Specifies the number of lines that your console screen will display.
more size lines
Syntax Definitions
lines Specify the number of lines for your console to display.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• If the display from the switch contains more lines than specified with this command, the switch will
display only the number of lines specified. The last line on your console will display as follows:
More? [next screen <sp>, next line <cr>, filter pattern </>, quit </>]
• To display more lines, press the spacebar to show another full screen, press Enter to show the next line,
or press q to quit the display and return to the system prompt.
Examples
-> more size 12
-> more size 30
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
SystemServices
systemServicesArg1
systemServicesAction
parameter default
lines 128
more Enables the more mode for your console screen display.
show more Shows the enable status of the more mode along with the number of
lines specified for the screen display.
To Next Page
Loading...
