File Management Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 7-37
vi
Launches the switch’s UNIX-like Vi text editor. The Vi file editor allows you to view or edit the contents
of a specified text file.
vi [path/]filename
Syntax Definitions
path The path (i.e., location) containing the file being viewed or edited. If no
path is specified, the command assumes the current directory.
filename The name of the existing file being viewed or edited. Up to thirty-two
(32) characters may be used (e.g., test_config_file).
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Until you exit the switch’s file editor, all keystrokes will be passed to the text editor rather than the
switch’s command line.
• This command can also be used on the secondary CMM.
Examples
-> vi test_config_file
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
systemServices
systemServicesArg1
systemServicesAction
view Allows you to view the contents of a specified file by invoking the Vi
text editor in read-only mode.
To Next Page
Loading...
