File Management Commands
page 7-38 OmniSwitch 6250 CLI Reference Guide November 2009
view
Allows you to view the contents of a specified file by invoking the Vi text editor in read-only mode.
view [path/]filename
Syntax Definitions
path The path directory leading to the file being viewed. If no path is speci-
fied, the command assumes the current directory.
filename The name of the existing file being viewed. Up to thirty-two (32) char-
acters may be used (e.g., test_config_file).
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
This command can also be used on the secondary CMM.
Examples
-> view flash/text_file.txt
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
systemServices
systemServicesArg1
systemServicesAction
vi Launches the switch’s Vi text editor.
To Next Page
Loading...
