File Management Commands
page 7-44 OmniSwitch 6250 CLI Reference Guide November 2009
ftp
Starts an FTP session.
ftp {host_name | ip_address}
Syntax Definitions
host_name Specifies the host name for the FTP session.
ip_address Specifies the IP address for the FTP session.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• You must have a valid username and password for the specified host.
• You can establish up to 9 FTP sessions from an OmniSwitch (when it acts as FTP Client) and up to 4
FTP sessions towards an OmniSwitch (when it acts as FTP Server).
• After logging in, FTP commands are supported. They are defined in the following table:
ascii Set transfer type to ASCII (7-bit).
binary Set transfer type to binary (8-bit).
bye Close session gracefully.
cd Change to a new directory on the remote machine.
delete Delete a file on the remote machine.
dir Obtain a long listing on the remote machine.
get Retrieve a file from the remote machine.
hash Print the hash symbol (#) for every block of data transferred. (This com-
mand toggles hash enabling and disabling.)
ls Display summary listing of the current directory on the remote host.
put Send a file to the remote machine.
pwd Display the current working directory on the remote host.
quit Close session gracefully.
remotehelp List the commands that the remote FTP server supports.
user Send new user information.
lpwd Display the current working directory on the local host.
? Display list of available FTP commands.
To Next Page
Loading...
