SNMP Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 10-19
snmp trap to webview
Enables the forwarding of traps to WebView.
snmp trap to webview {enable | disable}
Syntax Definitions
enable Enables WebView forwarding. When WebView forwarding is enabled,
all traps sent by switch applications are also forwarded to WebView.
This allows a WebView session to retrieve the trap history log.
disable Disables WebView forwarding.
Defaults
By default, WebView forwarding is enabled.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
To view the current WebView forwarding status, use the show snmp trap config command.
Examples
-> snmp trap to webview enable
-> snmp trap to webview disable
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
trapFilterTable
trapToWebView
show snmp trap config Displays the SNMP trap information, including the current status for
trap absorption and WebView forwarding.
To Next Page
Loading...
