Link Aggregation Commands
page 12-32 OmniSwitch 6250 CLI Reference Guide November 2009
lacp agg partner admin system id
Configures the partner administrative system ID for a dynamic aggregate group port.
lacp agg [ethernet | fastethernet | gigaethernet] slot/port partner admin system id
partner_admin_system_id
lacp agg [ethernet | fastethernet | gigaethernet] slot/port
no partner admin system id
Syntax Definitions
ethernet Documents that the port is 10 Mbps Ethernet.
fastethernet Documents that the port is 100 Mbps Fast Ethernet.
gigaethernet Documents that the port is Gigabit Ethernet.
slot The slot number for this aggregate.
port The port that the switch will initially use as the Spanning Tree virtual
port for this aggregate.
partner_admin_system_id The MAC address of the remote dynamic aggregate group in the hexa-
decimal format xx:xx:xx:xx:xx:xx.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to remove a partner administrative system ID from a slot and port
associated with a dynamic aggregate group.
• The ethernet, fastethernet, and gigaethernet keywords do not modify a port’s configuration. See
Chapter 20, “Ethernet Port Commands,” for information on CLI commands to configure Ethernet ports.
Examples
-> lacp agg 3/1 partner admin system id 00:20:da:05:f6:23
Release History
Release 6.6.1; command was introduced.
parameter default
partner_admin_system_id 0
To Next Page
Loading...
