Link Aggregation Commands
page 12-34 OmniSwitch 6250 CLI Reference Guide November 2009
lacp agg partner admin key
Configures the partner administrative key for a dynamic aggregate group port.
lacp agg [ethernet | fastethernet | gigaethernet] slot/port partner admin key partner_admin_key
lacp agg [ethernet | fastethernet | gigaethernet] slot/port no partner admin key
Syntax Definitions
ethernet Documents that the port is 10 Mbps Ethernet.
fastethernet Documents that the port is 100 Mbps Fast Ethernet.
gigaethernet Documents that the port is Gigabit Ethernet.
slot The slot number for this aggregate.
port The port that the switch will initially use as the Spanning Tree virtual
port for this aggregate.
parnter_admin_key The administrative key for the dynamic aggregation group’s remote
partner. Possible values are 0–65535.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to remove a partner admin key value from a slot and port associated
with a dynamic aggregate group.
• The ethernet, fastethernet, and gigaethernet keywords do not modify a port’s configuration. See
Chapter 20, “Ethernet Port Commands,” for information on CLI commands to configure Ethernet ports.
Examples
-> lacp agg 2/1 partner admin key 0
-> lacp agg 2/1 no partner admin key
Release History
Release 6.6.1; command was introduced.
parameter default
partner_admin_key 0
To Next Page
Loading...
