Link Aggregation Commands
page 12-38 OmniSwitch 6250 CLI Reference Guide November 2009
lacp agg actor port priority
Configures the priority for an actor port.
lacp agg [ethernet | fastethernet | gigaethernet] slot/port actor port priority actor_port_priority
lacp agg [ethernet | fastethernet | gigaethernet] slot/port no actor port priority
Syntax Definitions
ethernet Documents that the port is 10 Mbps Ethernet.
fastethernet Documents that the port is 100 Mbps Fast Ethernet.
gigaethernet Documents that the port is Gigabit Ethernet.
slot The slot number for this aggregate.
port The port that the switch will initially use as the Spanning Tree virtual
port for this aggregate.
actor_port_priority The priority of the actor port. Possible values are 0–255.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to remove an actor_port_priority value from a slot and port associ-
ated with a dynamic aggregate group.
• The ethernet, fastethernet, and gigaethernet keywords do not modify a port’s configuration. See
Chapter 20, “Ethernet Port Commands,” for information on CLI commands to configure Ethernet ports.
Examples
-> lacp agg 2/1 actor port priority 100
-> lacp agg 2/1 no actor port priority
Release History
Release 6.6.1; command was introduced.
parameter default
actor_port_priority 0
To Next Page
Loading...
