Link Aggregation Commands
page 12-42 OmniSwitch 6250 CLI Reference Guide November 2009
lacp agg partner admin port priority
Configures the priority for a partner port.
lacp agg [ethernet | fastethernet | gigaethernet] slot/port partner admin port priority
partner_admin_port_priority
lacp agg [ethernet | fastethernet | gigaethernet] slot/port
no partner admin port priority
Syntax Definitions
ethernet Documents that the port is 10 Mbps Ethernet.
fastethernet Documents that the port is 100 Mbps Fast Ethernet.
gigaethernet Documents that the port is Gigabit Ethernet.
slot The slot number for this aggregate.
port The port that the switch will initially use as the Spanning Tree virtual
port for this aggregate.
partner_admin_port_priority The priority of the partner port. Possible values are 0–255.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to remove a partner_admin_port_priority value from a slot and port
associated with a dynamic aggregate group.
• The ethernet, fastethernet, and gigaethernet keywords do not modify a port’s configuration. See
Chapter 20, “Ethernet Port Commands,” for information on CLI commands to configure Ethernet ports.
Examples
-> lacp agg 2/1 partner admin port priority 100
-> lacp agg 2/1 no partner admin port priority
Release History
Release 6.6.1; command was introduced.
parameter default
partner_admin_port_priority 0
To Next Page
Loading...
