Link Aggregation Commands
page 12-44 OmniSwitch 6250 CLI Reference Guide November 2009
show linkagg
Displays information about static and dynamic (LACP) aggregate groups.
show linkagg [agg_num]
Syntax Definitions
agg_num Specifies the aggregate group. Configured through the static linkagg
size or lacp linkagg size command.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• If no aggregation number is specified, information for all aggregate groups is displayed. If an aggre-
gate number is specified, information about that aggregate group is displayed only. The fields included
in the display depend on whether the aggregate group is a static or dynamic.
• Use the show linkagg port command to display information about aggregate group ports.
Examples
No aggregate group is specified:
-> show linkagg
Number Aggregate SNMP Id Size Admin State Oper State Att/Sel Ports
-------+----------+--------+----+-------------+-------------+-------------
1 Static 40000001 8 ENABLED UP 2 2
2 Dynamic 40000002 4 ENABLED DOWN 0 0
3 Dynamic 40000003 8 ENABLED DOWN 0 2
4 Dynamic 40000004 8 ENABLED UP 3 3
5 Static 40000005 2 DISABLED DOWN 0 0
Output fields are defined here:
output definitions
Number The aggregate group number.
Aggregate The type of aggregate group, which can be Static or Dynamic.
SNMP Id The SNMP ID associated with the aggregate group.
Size The number of links in this aggregate group.
To Next Page
Loading...
