802.1AB Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 13-9
lldp notification
Specifies the switch to control per port notification status about the remote device change.
lldp {slot/port | slot | chassis} notification {enable | disable}
Syntax Definitions
slot/port Slot number for the module and physical port number on that module
(e.g., 3/1 specifies port 1 on slot 3).
slot The slot number for a specific module.
enable Enables the notification of local system MIB changes.
disable Disables the notification.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• The LLDPDU administrative status must be in the receive state before using this command.
• If this command is applied to a slot or chassis, then the existing configuration related to this command
will be lost.
Examples
-> lldp 1/2 notification enable
-> lldp 1 notification disable
Release History
Release 6.6.1; command was introduced.
parameter default
enable | disable disable
To Next Page
Loading...
