802.1AB Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 13-11
lldp tlv management
Specifies the switch to control per port management TLVs to be incorporated in the LLDPDUs.
lldp {slot/port | slot | chassis} tlv management {port-description | system-name | system-description |
system-capabilities | management-address} {enable | disable}
Syntax Definitions
slot/port Slot number for the module and physical port number on that module
(e.g., 3/1 specifies port 1 on slot 3).
slot The slot number for a specific module.
port-description Enables or disables the transmission of port description TLV in
LLDPDU.
system-name Enables or disables the transmission of system name TLV in LLDPDU.
system-description Enables or disables transmission of system description TLV in
LLDPDU.
system-capabilities Enables or disables transmission of system capabilities TLV in
LLDPDU.
management-address Enables or disables transmission of management address on per port.
enable Enables management TLV LLDPDU transmission.
disable Disables management TLV LLDPDU transmission.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• The LLDPDU must be enabled and set to transmit before using this command.
• If this command is applied to a slot or chassis, then the existing configuration related to this command
will be lost.
Examples
-> lldp 1/2 tlv management port-description enable
-> lldp 2 tlv management management-address enable
-> lldp 3 tlv management system-name disable
parameter default
enable | disable disable
To Next Page
Loading...
