802.1AB Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 13-15
lldp tlv dot3
Specifies the switch to control per port 802.3 TLVs to be incorporated in the LLDPDUs.
lldp {slot/port | slot | chassis} tlv dot3 mac-phy {enable | disable}
Syntax Definitions
slot/port Slot number for the module and physical port number on that module
(e.g., 3/1 specifies port 1 on slot 3).
slot The slot number for a specific module.
enable Enables 802.3 TLV LLDPDU transmission.
disable Disables 802.3 TLV LLDPDU transmission.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• The LLDPDU must be enabled and set to transmit before using this command.
• If this command is applied to a slot or chassis, then the existing configuration related to this command
will be lost.
Examples
-> lldp 2/4 tlv dot3 mac-phy enable
-> lldp 2 tlv dot3 mac-phy disable
Release History
Release 6.6.1; command was introduced.
parameter default
enable | disable disable
To Next Page
Loading...
