CMM Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 1-15
show running-directory
Shows the directory from where the switch was booted.
show running-directory
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Once a switch has booted and is running, it will run either from the working or certified directory. If
running from the certified, changes made to the running configuration using CLI commands cannot be
saved. A switch must be running from the working directory in order to save the current running
configuration.
• This command can also be used on the secondary CMM.
Examples
-> show running-directory
CONFIGURATION STATUS
Running CMM : PRIMARY,
CMM Mode : DUAL CMMs,
Current CMM Slot : 1,
Running configuration : WORKING,
Certify/Restore Status : CERTIFY NEEDED
SYNCHRONIZATION STATUS
Flash Between CMMs : SYNCHRONIZED,
Running Configuration : NOT AVAILABLE,
Stacks Reload on Takeover: ALL STACKs (SW Activation)
output definitions
Running CMM The CMM currently controlling the switch, either PRIMARY or
SECONDARY.
CMM Mode Displays whether the primary and secondary CMMs are synchronized.
In the case that there is no secondary CMM, MONO-CMM-CHASSIS
is shown.
Current CMM Slot The slot number of the primary CMM.
Running Configuration Where the switch is running from, either WORKING or CERTIFIED.
A switch running from the certified directory will not be able to manip-
ulate files in the directory structure.
To Next Page
Loading...
