Distributed Spanning Tree Commands
page 16-30 OmniSwitch 6250 CLI Reference Guide November 2009
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
vStpInsTable
vStpInsNumber
vStpInsMode
vStpInsBridgeHelloTime
bridge mode Selects the Spanning Tree operating mode (flat or 1x1) for the switch.
bridge cist hello time Explicit command for changing the Spanning Tree hello time value for
the CIST instance when the switch is operating in either the flat or 1x1
mode.
bridge 1x1 hello time Explicit command for changing the Spanning Tree hello time value for a
VLAN instance when the switch is operating in either the flat or 1x1
mode.
To Next Page
Loading...
