Distributed Spanning Tree Commands
page 16-58 OmniSwitch 6250 CLI Reference Guide November 2009
Examples
-> bridge mode flat
-> bridge 1x1 2 4/1 enable
-> bridge 1x1 3 16 disable
-> bridge mode 1x1
-> bridge 1x1 2 5/10 enable
-> bridge 1x1 3 22 disable
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
vStpInsPortTable
vStpInsPortNumber
vStpInsPortEnable
bridge mode Selects the Spanning Tree operating mode (flat or 1x1) for the switch.
bridge slot/port Implicit command for configuring the Spanning Tree status on a port for
the flat mode CIST instance or for a 1x1 mode VLAN instance.
bridge cist slot/port Explicit command for configuring the Spanning Tree status on a port or
an aggregate of ports for the CIST instance when the switch is operating
in either the 1x1 or flat mode.
vlan stp Enables or disables Spanning Tree instance for the specified VLAN.
bridge bpdu-switching Enables or disables BPDU switching for the specified VLAN.
To Next Page
Loading...
