Distributed Spanning Tree Commands
page 16-70 OmniSwitch 6250 CLI Reference Guide November 2009
Related Commands
MIB Objects
vStpInsPortTable
vStpInsPortNumber
vStpInsPortPathCost
bridge mode Selects the Spanning Tree operating mode (flat or 1x1) for the switch.
bridge path cost mode Selects a 32-bit or automatic path cost mode for the switch.
bridge cist slot/port path cost Explicit command for configuring the Spanning Tree path cost for a port
or an aggregate of ports for the CIST instance when the switch is operat-
ing in either the 1x1 or flat mode.
bridge msti slot/port path cost Explicit command for configuring the Spanning Tree path cost for a port
or an aggregate of ports for an MSTI when the switch is operating in
either the 1x1 or flat mode.
bridge 1x1 slot/port path cost Explicit command for configuring the Spanning Tree path cost for a port
or an aggregate of ports for a VLAN instance when the switch is operat-
ing in either the 1x1 or flat mode.
To Next Page
Loading...
