Distributed Spanning Tree Commands
page 16-82 OmniSwitch 6250 CLI Reference Guide November 2009
Examples
-> bridge mode flat
-> bridge 1 4/1 mode forwarding
-> bridge mode 1x1
-> bridge 200 4/1 mode dynamic
-> bridge 300 1/24 mode forwarding
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
vStpInsPortTable
vStpInsPortNumber
vStpInsPortManualMode
bridge mode Selects the Spanning Tree operating mode (flat or 1x1) for the switch.
bridge cist slot/port mode Explicit command for configuring the Spanning Tree mode on a port or
an aggregate of ports for the CIST instance when the switch is operating
in either the 1x1 or flat mode.
bridge 1x1 slot/port mode Explicit command for configuring the Spanning Tree mode on a port or
an aggregate of ports for a VLAN instance when the switch is operating
in either the 1x1 or flat mode.
To Next Page
Loading...
