Distributed Spanning Tree Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 16-163
show spantree msti vlan-map
Displays the range of VLANs associated with the specified Multiple Spanning Tree Instance (MSTI).
show spantree mst [msti_id] vlan-map
Syntax Definitions
msti_id An existing MSTI ID number (0–4094).
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• If an msti_id is not specified, then the VLAN to MSTI mapping for all defined MSTIs is displayed.
• This command is available when the switch is operating in either the 1x1 or flat Spanning Tree mode.
• Initially all VLANs are associated with the flat mode CIST instance (also known as MSTI 0).
Examples
-> show spantree msti vlan-map
Spanning Tree Msti/Cist Vlan map
-----------------------------------
Cist
Name :
VLAN list : 1-9,14-4094
Msti 1
Name :
VLAN list : 10-11
Msti 2
Name :
VLAN list : 12-13
-> show spantree msti 2 vlan-map
Spanning Tree Msti Vlan map
-----------------------------
Msti 2
Name :
VLAN list : 12-13
To Next Page
Loading...
