Loopback Detection Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 17-5
loopback-detection transmission-timer
Configures the LBD transmission timer on the switch.The transmission time is the time period between
the consecutive LBD packet transmissions.
loopback-detection transmission-timer seconds
Syntax Definitions
seconds The time period in seconds between LBD packet transmissions. The
valid range is from 5 to 600 seconds.
Defaults
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
• If the timer value is not configured, the default value of 30 seconds is assigned to the transmission
period.
• The timer can be modified at any time. However, the new timer value will come into effect only after
the timer is restarted.
Examples
-> loopback-detection transmission-timer 200
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaLdbConfigTable
alaLdbGLobalConfigTransmissionTimer
parameter default
seconds 30
loopback-detection Enables or disables LBD globally on the switch.
show loopback-detection Displays LBD configuration information.
To Next Page
Loading...
