Learned Port Security Commands
page 19-14 OmniSwitch 6250 CLI Reference Guide November 2009
Examples
-> port-security 4/20 mac-range low 00:20:95:00:fa:5c
-> port-security 5/11-15 mac-range low 00:da:95:00:00:10 high 00:da:95:00:00:1f
-> port-security 5/16-20 mac-range high 00:da:95:00:00:1f
-> port-security 5/11-15 mac-range
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
learnedPortSecurityTable
lpsLoMacRange
lpsHiMacRange
lpsRowStatus
port-security Enables or disables Learned Port Security (LPS) on the switch port(s).
port-security mac Configures a single authorized source MAC address for a port that
belongs to a specified VLAN.
port-security shutdown Configures the amount of time in minutes to allow source learning on all
LPS ports. Also, enables or disables the conversion of dynamic MAC
addresses to static MAC addresses on LPS ports.
port-security maximum Specifies the maximum number of source MAC addresses that an LPS
port(s) is allowed to learn.
port-security violation Selects the method for handling traffic that does not comply with LPS
restrictions for the specified port.
To Next Page
Loading...
